Die cast aluminum dust remover is a chemical agent used to remove the oxide film and other impurities on the surface of die cast aluminum parts. The following are the correct steps for using die cast aluminum dust remover:
Preparation work: Before using die cast aluminum dust remover, the first step is to prepare well. Ensure good ventilation in the work area and wear appropriate protective equipment such as gloves, goggles, and protective clothing.
Cleaning the surface of castings: Before using a dust remover, it is necessary to clean the surface of castings to remove oil and impurities, in order to ensure the effectiveness of the dust remover.
Apply plastering agent: Apply the plastering agent evenly to the surface of the casting, ensuring that the entire surface is covered. You can use a brush or spray to apply.
Soaking time: According to the instructions for using the ash remover, let it stay on the surface of the casting for a certain period of time, usually ranging from a few minutes to several tens of minutes. This time can allow the ash remover to fully exert its function, dissolve and remove oxides and impurities on the surface of the casting.
Rinse and clean: After the idle time, rinse and clean the casting with clean water or cleaning solvent, thoroughly cleaning the ash remover and dissolved oxides.
Drying treatment: After the casting is cleaned, perform drying treatment to ensure the surface is dry and prevent oxidation from happening again.
Inspect the surface: Finally, inspect the surface of the casting to ensure that the ash remover removes all oxide films and impurities, and the surface of the casting becomes clean and smooth.
The above are the basic steps for using die cast aluminum dust remover. When using, it is necessary to strictly follow the instructions and safety operating procedures to ensure safe use
